Ocean Optics USB2000+ Install - Manual (Page 14)

2: Installing the USB2000+
8 270-00000-000-02-201107
the graph. If you allow light into the spectrometer, the graph trace should rise with increasing light
intensity. This means the software and hardware are correctly installed.
Note the spectrometer(s) that you have installed are listed in the Data Sources pane.
Configuring the USB2000+ in OOIBase32
Once you install the USB2000+, you must configure OOIBase32’s Configure Spectrometer options so
that OOIBase32 recognizes the USB2000+ Spectrometer. Consult the OOIBase32 Spectrometer
Operating Software Operating Instructions for detailed instructions on configuring the spectrometer in
OOIBase32 (see
Product-Related Documentation ).
External Triggering Options
You can trigger the USB2000+ using a variety of External Triggering options through the 30-pin
Accessory Connector on the spectrometer. For USB2000+ firmware versions below 3.0, see the External
Triggering Options document located at
http://www.oceanoptics.com/technical/External-
Triggering.pdf . For USB2000+ firmware version 3.0 and above, see the External Triggering Options
document located at http://www.oceanoptics.com/technical/External-Triggering2.pdf . The triggering
document contains instructions for configuring External Triggering options for the USB2000+.