Ocean Optics MonoScan2000 - Manual (Page 12)

1: Setup
4 000-10000-150-02-201011
7. Go to the Connection settings menu and select the Comport to which the MonoScan-2000 is
connected.
8. Go to Connection settings menu and select Connect to establish a connection between the PC and
the MonoScan-2000 (the MonoScan-2000 will run to its internal reference and will be set to
250nm).
9. If the device is found on the chosen Comport, the following message appears:
All buttons then become enabled.
10. Set another wavelength by clicking on one of the buttons (<10nm, <1nm, 1nm >, 10nm >) or
enter a wavelength and click Goto.
11. When the measurements are finished, close the connection between the PC and the MonoScan-
2000 in the Connection settings – Disconnect menu.