Ocean Optics HL-2000-FHSA - Manual (Page 21)

000-10000-070-02-201307 13
Appendix A
Bulb Replacement
Overview
To order replacement bulbs for the HL-2000-FHSA, consult the Parts List .
WARNING
Before replacing the bulb in the HL-2000-FHSA, disconnect the lamp from your
power source and allow the unit to cool for at least twenty minutes, if necessary.
Replacing the Bulb
► Procedure
Refer to Figure 5 and perform the steps below to replace the bulb in the HL-2000-FHSA Light
Source:
1. Unplug the power connector from the power socket on the HL-2000-FHSA.
2. Loosen the screws on the rear of the unit with the provided 2.5mm Allen wrench.
3. Remove the rear of the HL-2000-FHSA and remove the electronics board from the unit, taking
particular care not to disconnect the fan wires.
4. Remove the screws from the bottom plate of the unit with the provided 1.3mm Allen key.
5. Remove the bulb from the HL-2000-FHSA.
6. Disconnect the wires from the connection block.
7. Replace the bulb and reconnect the wires to the connection block.
8. Slide the lamp into the housing and secure the housing with the bottom screw.