Ocean Optics PinPointer - Manual (Page 12)

Page 11
CLASS III b LASER PRODUCT
AVOID DIRECT EXPOSURE TO BEAM
The Scan Time setting determines the quality of the measurement signal received from
any sample under test. An optimum signal from any sample improves the chance that a
match will be found in the database and the material can be identified by the PinPointer
It is recommended that the Tune function be utilized for most samples.
This may result in a longer measurement cycle.
Experienced users will develop a sense for the best scan time to use to reduce routine
measurement cycles, especially for repetitive sample measurements.
The scan time can be set manually. Use the small arrows to the right of
the number to increase or decrease the set value. Touch the large arrow
to access the numerical keypad shown below.