Ocean Optics ADC2000-PCI - Manual (Page 5)

Installing and Using the ADC2000-PCI
2 Installing and Using the ADC2000-PCI
This chapter provides instruction on installing and configuring the ADC2000-PCI:
Install OOIBase32
Before installing your ADC2000-PCI hardware, you must first install the OOIBase32 Spectrometer Operating
Software. It is critical that the software be installed prior to hardware installation.
Consult the OOIBase32 operating instructions for specific installation instructions. You can view the latest version
of the OOIBase32 Operating Instructions on your Software and Technical Resources CD, or by visiting the
following web address:
http://www.oceanoptics.com/technical/ooibase32bit.pdf
Note: If you installed the hardware prior to installing OOIBase32, you will not be able to load the drivers for the
ADC2000-PCI. For instructions on fixing this issue, consult the Correcting Device Driver Issues
document at the following address:
http://www.oceanoptics.com/technical/engineering/correctingdevicedriverissues.pdf
Install the ADC2000-PCI Hardware
Follow the instructions below to install the ADC2000-PCI card in your PC:
1. Turn off the computer and remove the PC access panel.
PC with access panel removed
2. Ground yourself to the computer chassis or power supply.
ADC2000-PCI Operating Instructions 2
3. Remove the ADC2000-PCI card from its static-shielded bag.