Ocean Optics ecoVis Krypton Light Source - Manual (Page 10)

1: Setup
2 000-10000-180-02-201401
Setup Instructions
The following sections provide instructions on unpacking and setting up your ecoVis Light Source.
Before using the ecoVis for the first time, check for transport damage. Be sure to adhere to all warnings
on the unit and in this manual.
Unpacking the ecoVis
►
Procedure
1. Unpack your lamp assembly carefully. Although the lamp is rigidly mounted, dropping this
instrument can cause permanent damage.
2. Inspect the outside of the instrument and make sure that there is no damage. Do not use the
instrument if damage is present. Contact your dealer for repair or replacement information, if
necessary.
3. Use this instrument in a clean laboratory environment.
Contents
Your ecoVis package should contain the following:
 ecoVis Light Source
 Multi-plug AC-adaptor 3.5 Vdc output
 Hexagon socket screw key (Allen wrench) SW 1.3