QTECH SmartEdge 600 Configuration - Manual (Page 29)

Configuration and Operations
Table 30 AAA Operations Tasks
Task Root Command
Generate AAA debug messages. debug aaa
Modify a subscriber attribute in real time during an active
session, using the CLI. policy-refresh
Modify a subscriber attribute in real time during an active
session, using the RADIUS authentication process. reauthorize
Test the communications link to a RADIUS server. test aaa
2.6 Configuring AAA Route Download
To configure AAA route download, you must configure the AAA route-download
server and route-download capabilities.
2.6.1 Configuring the AAA Route-Download Server
To configure a route-download server:
1. Use the configure command to access global configuration mode.
2. Use the context command to access context configuration mode.
3. Use the radius route-download server command to designate a RADIUS
route-download server, and configure the shared key (encrypted or not) and
optional port. If the port is not specified, 1812 is used as the default value.
2.6.2 Configuring Route-Download Capabilities
Once you have configured a route-download server, you can configure
route-download capability in context configuration mode:
1. Use the radius route-download algorithm command to specify the
load-balancing algorithm to be used when multiple servers are configured.
By default , the request is sent to the first available RADIUS server. You
can also configure round-robin load balancing.
2. Use the radius route-download deadtime command to specify the interval in
minutes for declaring a RADIUS route-download server unavailable before
declaring it as available again. The range is 0 to 65,535. If not specified,
the server is not declared as available again. The default deadtime value
is 5 minutes.
3. Use the radius route-download max-retries command to specify the
maximum number of times a route download request is retried. The range
is 1 to 2,147,483,647. The default value is 3.
25 61/1543-CRA 119 1170/1 Uen L | 2012-12-04