QTECH SmartEdge 600 Configuration - Manual (Page 18)

Configuring Authentication, Authorization, and Accounting
2.2.2.5 Configure Context-Specific RADIUS Authentication
To authenticate subscribers using one or more RADIUS servers with IP
addresses or hostnames configured in the current context, perform the task
described in Table 14.
Table 14 Context-Specific RADIUS Authentication
Task Root Command Notes
Configure context-specific RADIUS
authentication. aaa authentication subs
criber Enter this command in the context
configuration mode.
Use the radius keyword with this
command to configure RADIUS
authentication.
At least one RADIUS server
IP address or hostname must
be configured in the current
context; for more information, see
Configuring RADIUS.
2.2.2.6 Authenticate Router (Local)
To authenticate subscribers through the router configuration, perform the task
described in Table 15.
Table 15 Router Configuration Authentication
Task Root Command Notes
Configure router configuration
authentication. aaa authentication subs
criber Enter this command in the context
configuration mode.
Use the local keyword with this
command to configure RADIUS
authentication.
2.2.2.7 Configure DHCPv6 Interface Authentication
Enable AAA to authenticate subscribers through the router local database.
Subscribers are authenticated according to parameters set in the subscriber
profile for the current context. In the subscriber local context, to configure an
interface as a DHCPv6 interface, AAA must be enabled to provide subscriber
authentication. To authenticate subscribers through a DHCPv6 server, perform
the tasks described in Table 16.
14 61/1543-CRA 119 1170/1 Uen L | 2012-12-04