QTECH SmartEdge 600 Configuration - Manual (Page 24)

Configuring Authentication, Authorization, and Accounting
2.4.2 Configuring Administrator Accounting
To enable accounting messages for administrator sessions to be sent to the
TACACS+ server, perform the task described in Table 25.
Table 25 Administrator Accounting
Task Root Command Notes
Configure administrator
accounting. aaa accounting administrator Enter this command in the context
configuration mode.
A TACACS+ server must be
configured in the specified context;
see Configuring TACACS+.
2.4.3 Configuring Subscriber Accounting
To configure subscriber accounting, you must perform the following tasks:
• Configure Global Subscriber Accounting
• Configure Context-Specific Subscriber Accounting
• Configure Two-Stage Subscriber Accounting
2.4.3.1 Configure Global Subscriber Accounting
To configure global subscriber accounting, perform the tasks described in
Table 26.
Note: Before configuring global subscriber accounting, you must configure
local subscriber authentication; for more information, see Configure
Global RADIUS Authentication earlier in this section. You must also
configure at least one RADIUS accounting server in the local context;
for more information, see Configuring RADIUS.
Table 26 Global Subscriber Accounting
Task Root Command Notes
Enable global
subscriber session
accounting
messages. aaa global accounting subscriber Enter this command in the global
configuration mode.
Accounting messages for
subscriber sessions in all
contexts are sent to one or more
RADIUS accounting servers
with IP addresses or hostnames
configured in the local context.
20 61/1543-CRA 119 1170/1 Uen L | 2012-12-04