English, Faucet installation – Pfister GT26-3NSS User Manual

Page 2

ENGLISH

ENGLISH

FAUCET INSTALLATION

Thank you for purchasing this Price Pﬁster product. All Price Pﬁster products are carefully engineered, and factory tested to
provide long trouble-free use under normal conditions. This product is easy to install using basic tools and our easy to follow
illustrated instructions. If you have any questions regarding this product, call 1-800-Pfaucet (1-800-732-8238).

1 BEFORE PROCEEDING

WARNING: Read all the instructions completely before proceeding. Price Pﬁster

recommends calling a professional if you are uncertain about installing this product!
This product should be installed in accordance with all local and state plumbing and
building codes.

2 SHUT OFF WATER SUPPLY

Locate water supply inlets and shut off the water supply valves. These are usually found
under the sink or near the water meter. If you are replacing an existing faucet, remove
the old faucet from the sink and clean the sink surface thoroughly.

3 TOOLS RECOMMENDED

• Plumber's putty

• Slotted screwdriver

• Pliers

• Adjustable wrench

• Flashlight

• Cloth

Your installation may require new supply lines and / or shut-off valves or other additional
tools.

4 CHECKING THE CONTENTS OF THE BOX

Upon opening the box, check to ensure that all of the following items are included:

A Spout Body

B Control Body

C Side Spray

D Hose Guide

E Gaskets (2X)

F Washers (2X)

G Locknuts (2X)

H Soap Dispenser

J Diverter

K Clip

If any of these items are missing, please contact Price Pﬁster Consumer Services at
1-800-Pfaucet (1-800-732-8238).

5 SPOUT BODY INSTALLATION

Apply plumber’s putty into groove on bottom of Gasket (5A) per manufacturer’s
recommendations. Place Gasket (5A) under base of Spout Body (5B). From above sink,
insert Mounting Shank (5C) through center hole of sink.

6 SECURING SPOUT BODY

From underneath sink, place large Washer (6A), and Locknut (6B) onto Mounting Shank
(6C). Tighten faucet ﬁrmly to sink.