Crown Audio PIP-USP4 Module - Manual (Page 8)

Networked PIP Series
Reference Manual page 8
Slide PIP Into Amplifier
BACK PANEL
OF PIP
AMPLIFIER
Rotate PIP Module 180 o
Plug In CABLE A
Plug In CABLE B
Rotate PIP Module 180 o
In Opposite Direction
Connect the PIP-Lite Module to the
Amplifi er
1. Turn the PIP module upside down so the
ribbon cable connectors located along the
back edge on the underside of the module can
be clearly seen.
2. Attach the ribbon cables from the amplifi er to
the ribbon-cable connectors. The 20-pin cable
(A) should connect to the connector (J2A)
closest to the corner and the 18 pin cable (B)
should connect to the other connector.
Important: Be careful when attaching the ribbon
cable to the connector. Don’t pull cables out if they
are short. Applying pressure to an improperly seated
connector could cause the keying tabs, which ensure
proper pin alignment, to break. Connecting the
ribbon cables with improper pin alignment will likely
result in damage to the PIP module.
Mount the PIP Module in the Amplifi er
1. With both cables fi rmly attached, turn the PIP
to an upright position. Verify that the cables run
untwisted between the amplifi er and the PIP
module.
2. Insert the PIP module into the amplifi er while
taking care not to crimp, pinch or stretch the
ribbon cables.
3. Fasten the PIP module to the amplifi er rear
panel with the two supplied mounting screws.
Be sure to use the supplied star-washers for a
good ground connection.