Factory Direct Hardware Von Duprin 2227EOF4 - Manual (Page 12)

911334_00(7) Page 12 of 16
Install rod guides, center case cover, and latch covers. 12
12.1. Disconnect top and bottom rods from center
case. Slide rod guide bases 1 (with legs of
bases against door) onto rods. Connect rods to
center case.
12.2. Install center case cover 2 .
12.3. Place rod guides 3 over rod guide bases 1 .
Position rod guide/base midway between
center case and latch and mark and prepare
rod guide mounting holes:
Metal door: #25 drill and #10-24 tap, inside
Wood door: 1/8” dia. pilot drill x 3/4” deep, inside
12.4. Install rod guides 3 over rod guide bases 1 .
12.5. Install latch covers 4 .
If using rod or latch guards, skip this step
and see rod or latch guard instructions.
NOTE
!
1
1
2
3
4
4
3
Center case: Use screws
from end cap package:
#8-18 undercut
flat head machine
1/2”
#10-12 x 10-24
combination
Rod guides: Use screws from
rod guide mounting package:
1”
#8-32 undercut
flat head machine
Latch covers: Use screws from
latch cover mounting package:
1/4”