3B Scientific 3B NETlog™ with Ethernet Port (230 V, 50__60 Hz) - Manual (Page 6)

6
Setting and selecting measurement parameters:
• Press the Channel
← button (the menu DIS-
PLAY SIGNAL 1 will appear on the display).
• Select the desired measurement parameter
with the Rate
↑ or the Store ↓ button.
• Select the mode of operation with the
Date/Time
↵ button (the menu RANGE SIGNAL
1 will appear on the display).
• Select the desired mode of operation with the
Rate
↑ or the Store ↓ button.
• Confirm this selection with the Date/Time
↵
button (the menu DISPLAY SIGNAL 2 will ap-
pear on the display).
• Select the desired measurement parameter
with the Rate
↑ or the Store ↓ button.
• Select the desired mode of operation with the
Rate
↑ or the Store ↓ button.
• Confirm the selection with the Date/Time
↵
button (a dot will appear in front of the respec-
tive measurement parameter when operating
manually).
The 3B NETlog™ device is ready to conduct meas-
urements.
8.5 Application as a handheld measuring
device with sensors
• Set up the 3B NETlog™ equipment.
• Connect the sensor to the relevant input and
remove the connections of the 4-mm sockets
from the same channel.
After the automatic sensor detection PROBE DE-
TECT… has been completed, the 3B
NETlog™
equipment is ready to conduct measurements.
8.6 Setting the sampling rate
• Press the Rate
↑ button (the options list for
SAMPLE RATE will appear).
• Select the desired sampling rate with the
Rate
↑ or the Store ↓ button.
• Press the Date/Time
↵ button (the settings
STORE ANALOGUE INPUT 1, STORE ANALOGUE
INPUT 2 and STORE BINARY INPUTS will appear
in succession).
• Select YES or NO for each setting with the
Rate
↑ or the Store ↓ button and confirm with
the Date/Time
↵ button (the subsequent set-
ting will appear after each confirmation).
8.7 Data logger
In data logger mode, the 3B NETlog™ equipment
records the data with a pre-selected sampling rate
and saves it internally. After completing a meas-
urement, the data can be transferred onto a com-
puter for evaluation.
Calling up data logger mode:
• Press the Store
↓ button (STORE will appear
with
→ START or ↑ CLEAR → START dis-
played).
Starting data logger:
When the display shows
→ START:
• Start recording data with the Date/Time
↵
button (“BUSY
→ STOP” will appear in the dis-
play and the measurement begins).
Stopping the data logger:
When the display shows
→ STOP:
• Stop recording data by pressing the
Date/Time
↵ button (↑ CLEAR → START will
appear in the display).
Clearing data logger:
When the display shows
↑ CLEAR:
• Press the Rate
↑ button (MEM.CLEAR? → YES
will appear in the display).
• Confirm by pressing the Date/Time
↵ button.
Exiting data logger mode:
When the display shows
↑ CLEAR → START:
• Press the Channel
← button.
9. Use of Ethernet port
In order to connect the 3B NETlog™ unit into a
local network using its Ethernet port, carry out the
following procedure:
9.1 Assignment of an IP address by the router
• Turn off the 3B NETlog™ device and unplug the
Ethernet cable.
• Press down the "STORE" button and turn on
the 3B NETlog™. The display should show the
following: