Prokit's Industries SS-227 - Manual (Page 4)

4
CAUTION: Improper usage can cause serious injury to personnel
and/or
SAFETY PRECAUTIONS
●
Check each component after opening the package to make sure
everything is in good condition. If there are any suspected dam-
age, do not use the item and report the issue to your vendor.
●
Turn OFF the main power switch and unplug the device from
power source when moving the device.
● Do not strike or subject the main unit (and all its components) to
physical shock. Use carefully to avoid damage to any part.
●
Handle with care.
- Never drop or sharply jolt the unit.
- Contains delicate parts that may break if the unit is dropped.
● Make sure the equipment is always grounded. Always connect
power to a grounded receptacle.
●
Temperature may reach as high as 480°C when switched ON.
- Do not use the device near flammable gases, paper and other flammable
materials.
- Do not touch heated parts, which can cause severe burns.
●
Disconnect the plug from the power source if the unit will not be
used for a long period.
- Turn off power during breaks, if possible.
●
Use only genuine replacement parts.
- Turn off power and let the unit cool down before replacing any part.
●
The unit may produce a small amount of smoke and unusual odor
during initial usage. This is normal and should not yield any nega-
tive result when reworking.
●
Soldering process produces smoke — use on well ventilated places.
● Do not alter the unit, specifically the internal circuitry, in any man-
ner.
17
保养
SPECIFICATION
操作指南
C. 睡眠功能
1.烙铁笔设有振动感应器。
2.当烙铁笔处于不使用状态，系统将自动进行倒计时。
3.通过以下方法可调睡眠计时功能。
a . 按住设定按键，过几秒后上排显示为“SET01”，这表明我们 可
以设定睡眠时间。
b. 按加或减按钮可调睡眠计时。如果显示“t000”，这等于睡眠功能
关闭。如果显示“t030”，睡眠功能是打开，并在30分钟后进入睡
眠状态。
c. 重复按设定按键，直到下排显示“SAUE＂。此时按减按钮可保存
设定到内存并从设置模式退出。
4.如果睡眠功能倒计时已经开始，屏幕上会显示字母“b”。
5.当显示系统进入睡眠状态显示会有两个破折号“ - - ＂。如果 想唤醒
系统，拿起烙铁笔或按任何按钮，系统会立即开启， 恢复工作。
D.系统锁定
1.按下面的方法可设定系统锁定功能：
a.按住设定按键，过几秒后上排显示为“SET01”。
b.反复按设置按钮，上排显示“SET02”，下排显示“OFF＂。按加或减
按钮可切换“ON”和“OFF”。
c.重复按设定按键，直到下排显示“SAUE＂；按减按钮可保存设定到内
存里，并从设置模式退出。
d.当系统锁定已启动，按任何按钮，屏幕会显示字“SAFE＂指系统被
锁定了。
e.要解开系统锁定，同时按住三个按钮等过10秒后就会解锁。