Newport Brass 280D - Manual

Recommended Installation by a Professional Plumbing Contractor
Locate the desired position of slide bar on finished wall. See Fig. 1.
Mark wall and drill 5/16” hole for WALL ANCHORS (1) to dimension
shown in Figure 1.
Place SLIDE BAR (2) into END POST (3). Note: Large diameter hole in
SLIDE BAR (2) must face out as shown in Figure 2.
Place POST (3) onto ESCUTCHEON (4), insert SCREW (5) & securely
tighten into ANCHOR (1) as shown in Figure 2.
Press END CAP (6) into end of POST (3).
Slide and lock HOLDER ASSEMBLY (7) onto SLIDE BAR (2) and repeat the above steps to the
other end of SLIDE BAR (2) as shown in Figure 3.
NWP-280D 10/10/2011
INSTALLATION INSTRUCTIONS
SLIDE BAR ASSEMBLY
MODEL NO. 280D
Figure 2
6
5
3
2
4
1
Figure 3
1
4
3
5
6
7
2
23”
Figure 1
1