Newport Brass 26-12 Towel Ring_Garment Hook - Manual

Towel Ring / Garment Hook
Installation Instructions
Model No.
26-09, 26-12
Recommended Installation by a Professional Contractor
1. Hold the BASE (1) up to desired location and mark the hole locations on flange.
2. Drill holes in wall at points marked using the appropriate drill size:
· Wood Screw (#10 x 1 3/4”) - use: 1/8" Drill
· Toggle Screw (10-24 x 3”) - use: 9/16" Drill
3. Fasten BASE (1) to wall using either WOOD/TOGGLE SCREWS (2). Align BASE (1) so
upper flat is level. (See Fig. 1)
4.Thread POST (3) into BASE (1). Position POST (3) height to 2” from mounting surface
and secure in place by tightening the SETSCREW (4). (See Fig. 2)
5. Place ESCUTCHEON (5) over wall mounted POST (3). (See Fig. 3)
5a. Towel Ring: Slide END POST (6) onto POST (3) and secure into place with
SETSCREW (4). (See Fig. 4)
5b. Garment Hook: Slide END POST (6) onto POST (3) and secure into place with
SETSCREW (4). (See Fig. 5)
Fig. 1
3
5
Fig. 3
Fig. 4 Fig. 5
6
6
4
3
4
3
2
Fig. 2
1
2-1/16” 1
3
4