Newport Brass 33-28 - Manual

Towel Bar / Tissue Holder
Installation Instructions
Model No. 33-01, 33-02, 31-04, 31-28
Recommended Installation by a Professional Contractor
1. Measure the appropriate distance between post centers. See Figure 1.
Note: Hole locations should be level.
• 18” Single Towel Bar: 18-5/16”
• 24” Single Towel Bar:
XX ”
• 18” Double Towel Bar: 18 7/16 ”
• Tissue Holder (2 Post): 6 1/4”
2. Drill hole(s) in wall at points marked using the appropriate drill size:
· Wood Screw (#6 x 2”) - use: 3/32" Drill
· Toggle Screw (6-32 x 3”) - use: 3/8" Drill
3. Fasten FLANGE (1) to wall using either WOOD/TOGGLE SCREWS (2). See Figure 2.
4. Place POST (3) into FLANGE (1). Position POST (3) height to 2-1/16“ from mounting
surface. Secure POST (3) into place by tightening SETSCREW (4). See Figure 2.
5. Place ESCUTCHEON (5) and then BONNET (4) onto POST (3). See Figure 3.
5a. Towel Bar: Assemble TOWEL BAR (6) between END POST (7). With ESCUTCHEON (5)
place onto FLANGE POST (1). Secure onto place with SETSCREW (4). See Figure 3.
5b. DoubleTowel Bar: Assemble TOWEL BARS (6) between END POST (7). Place END POST
(7) onto FLANGE POST (1). Secure onto place with SETSCREW (4). See Figure 4.
5c.Tissue Holder: Place END POST (7) onto FLANGE POST (1). Secure into place with
SETSCREW (4). Place HOLDER (10) between END POST (7). See Figure 5.
Fig. 1
Fig. 2
Fig. 3
2 1
Distance
between posts
See Table A
7
6
4
3
1
4
10
7
Fig. 5 Fig. 4
4
1
7
5
2 1/16”
4
6
4
3