Newport Brass 26-30 - Manual

2001 CARNEGIE AVE
SANTA ANA, CA 92705
©2010 Brasstech, Inc. Newport Brass is a registered trademark of Brasstech, Inc.
www.newportbrass.com
Open Towel Ring, Double Garment Hook,
Single Post & Reserve Tissue Holder
Installation Instructions
Model No.
26-10, 26-13, 26-27, 26-30
Recommended Installation by a Professional Contractor
1. Hold the BASE (1) up to desired location and mark the hole locations on flange.
2. Drill holes in wall at points marked using the appropriate drill size:
· Wood Screw (#6 x 2”) - use: 3/32" Drill
· Toggle Screw (6-32 x 3”) - use: 3/8" Drill
3. Fasten BASE (1) to wall using either WOOD/TOGGLE SCREWS (2). Align BASE (1) so that
upper flat is level. (See Fig. 1)
4.Thread ADAPTER (3) onto BASE (1). Insert POST (4) into ADAPTER (3). Position POST (4)
height to 2 1/8” from mounting surface and secure in place by tightening the
SETSCREW (5). (See Fig. 2)
5. Place ESCUTCHEON (6) over wall mounted POST (4). (See Fig. 3)
5a. Open Towel Ring: Slide END POST (7) onto POST (4) and secure into place with
SETSCREW (5). (See Fig. 4)
5b. Double Garment Hook: Slide END POST (7) onto POST (4) and secure into
place with SETSCREW (5). (See Fig. 5)
5c. Single Post Tissue Holder: Slide END POST (7) onto POST (4) and secure into
place with SETSCREW (5). (See Fig. 6)
5d. Reserve Tissue Holder: Slide END POST (7) onto POST (4) and secure into
place with SETSCREW (5). (See Fig. 7)
Fig. 1
4
6
Fig. 3
Fig. 4
7
5
3
2
1
Fig. 2
1
Fig. 5
Fig. 6 Fig. 7
4
5
7
7
5
4
5 4
7
3
4
5
2 1/16”