Newport Brass 13-28 - Manual

Towel Bar / Towel Ring / Robe Hook / Tissue Holder
Installation Instructions
Model No.
13-01, 13-02, 13-03, 13-04, 13-05, 13-09, 13-12, 13-28
Recommended Installation by a Professional Contractor
1. Using the table below, measure the appropriate distance between post centers. See Fig. 1.
Note: Hole locations should be level.
· 18" Single Towel Bar - 18 7/16"
· 24" Single Towel Bar - 24 7/16"
· 30" Single Towel Bar - 30 7/16"
· 18" Double Towel Bar - 18 11/16"
· 24" Double Towel Bar - 24 11/16"
· Tissue Holder (2 Post) - 6 1/4"
2. Drill hole(s) in wall at points marked using the appropriate drill size:
· Wood Screw (#6 x 2”) - use: 3/32" Drill
· Toggle Screw (6-32 x 3”) - use: 3/8" Drill
3. Fasten FLANGE (1) to wall using either WOOD/TOGGLE SCREW (2). See Fig. 2.
4. Place ESCUTCHEON (3) onto the FLANGE (1). See Fig. 3.
4a. Towel Bars: Assemble BAR (5) into END POSTS (4). Slide onto FLANGE (1) and secure
into place with SETSCREW (6). See Fig. 4.
4b. Towel Ring / Robe Hook: Place END POSTS (4) onto FLANGE (1). Secure into place
with SETSCREW (6). See Fig. 5.
4c. Tissue Holder: Slide END POST (4) onto FLANGE (1) and secure into place with
SETSCREW (6). Place HOLDER (7) between END POSTS (4). See Fig. 6.
Distance between
posts
Fig. 1
Fig. 2
2
1
1
3
Fig. 3
Fig. 4 Fig. 6
5
4
6
4
1
7
6
1
Fig. 5
1
6
4