Newport Brass 3-996L East Linear User Manual
Page 2
Rough in valve Installation
Recommended Installation by a Professional Plumbing Contractor
Note: Use plumbers tape or equivalent to seal all threaded joints.
Warning: To prevent severe damage to valve body, any solder/braze process must be per-
formed a min. of 4" from ports.
1. Install the quick connect spout shank through center hole of mounting surface. Secure with
washer nut. See Fig. 1
2. Place washer nut on valve body. Insert body, (blue cold & red hot), through hole from
below mounting surface. See Fig. 1. Adjust and secure with additional washer nut so that the
top of valve stem is at the correct height from mounting surface. See Table 1.
Fig. 1
3/4 NPT
Washer
Nut
Spout nipple to
be used with
trim installation
Washer
Nut
Deck
Flange
See table for
stem length
Finished Deck
1 1/4”
1 1/4”
3/4 NPT
3. Attach hot/cold valves to spout, utilizing ¾" copper pipe. See Fig. 2
Fig. 2
Inlet for hot
water supply
Inlet for cold
water supply
NWP-1-502
EN-2621
Rev A
- 212 (2 pages)
- 941 (3 pages)
- 277-02 (2 pages)
- 12-27 (2 pages)
- 22-51 & 52 (3 pages)
- 120 Brasstech (1 page)
- 9451-1 (3 pages)
- 2540A Metro (3 pages)
- 22-28 (2 pages)
- 29-28 (1 page)
- 3-424 Kiara (2 pages)
- 280H (1 page)
- 7008X (4 pages)
- 283 (2 pages)
- 283-4 (2 pages)
- 3-1767 Victoria (4 pages)
- 2546 Metro (2 pages)
- 1-564 (1 page)
- 31-12 Towel Ring_Garment Hook (2 pages)
- 130 Brasstech (1 page)
- 29-52 (4 pages)
- 9452-1 (3 pages)
- 30-27 (2 pages)
- 104B (2 pages)
- 30-28 (2 pages)
- 280J (2 pages)
- 3-906 Kayan (4 pages)
- 281A (2 pages)
- 26-28 (2 pages)
- 281B (2 pages)
- 15-12 Towel Ring_Garment Hook (2 pages)
- 12-02 (1 page)
- 281C (2 pages)
- 29-30 (2 pages)
- 19-27 (2 pages)
- 39-28 (2 pages)
- 9901 (3 pages)
- 9453-1 (3 pages)
- 280M (2 pages)
- 2500-5503 (2 pages)
- 280A (2 pages)
- 22-12 Towel Ring_Garment Hook (2 pages)
- 1660 Astaire (4 pages)
- 2566 Skylar (3 pages)
- 281 (2 pages)