Newport Brass 3-1767 Victoria - Manual (Page 3)

Table 1
Trim Installation
Note: To achieve desired handle rotational alignment, the cartridge MUST be tightened in a clockwise
rotation only.
(Cartridge Bonnet factory torque is 14-16 ft-lbs.)
1. Attach handle and diverter trim to valves. Any adjustments for rotational alignment must be
made to the valve body - not to the cartridge. (Note: Allow minimum spacing between handles
and escutcheon/bonnet to prevent damage to the surface finish.) Secure handles into place with
screw and press cap into top of handle. See Figure 3.
2. Slide Base Ring** onto Spout Assembly, exposing the setscrew. Align and press spout assembly
onto quick connect deck flange. Make sure spout is flush with deck Secure spout onto quick con-
nect with setscrew. See Figure 3.
3. Install decorative ring to threaded deck flange. Attach braided hose, from diverter, to hand shower
decorative hose and assembly.
4. Turn on water supply, check for leaks and make any final adjustments required.
12/1/2006
Bonnet**
Escutcheon
Spout
Spout Base ring**
Valve
Quick connect
Deck flange
Threaded Deck Flange
Handle shower
Handle
** Optional item based on model selected
Figure 3
Screw**
Cap**
Diverter Valve
SERIES 3-1767 3-1777
STEM
LENGTH
2” 2”
NWP-1-587
EN-1735
REV A