KIA Rio_Rio5 2005 - Manual (Page 43)

3-33
Installing a Child Restraint in the Rear Center Seat
(If Equipped)
To install a child restraint in the rear center seat, do the
following:
1. Place the child restraint in the desired position.
Route the lap belt through the restraint according to
the seat manufacturer’s instructions.
2. Insert the tongue plate into the buckle until an audi-
ble “click” is heard, indicating the belt is locked in
the buckle.
3. Adjust the lap safety belt for a snug hold on the child
restraint by pulling on the loose end of the belt.
To return the safety belt retractor to the emergency
lock mode, allow the seat belt to retract fully to its
stowed position. The retractor will then automatically
switch back to the emergency lock mode for normal
adult usage.
WARNING - Auto Lock Mode
The lap/shoulder belt automatically returns to
the “emergency lock mode” whenever the belt
is allowed to retract fully. Therefore, the pre-
ceding six steps must be followed each time a
child restraint is installed.
If the safety belt is not placed in the “auto
lock” mode, severe injury or death could occur
to the child and/or other occupants in the vehi-
cle in a collision, since the child seat will not be
effectively held in place.
2MS103006
RIO ENG CNA 3.qxd 7/29/05 5:13 PM Page 33