Sena Bluetooth SMH5-FM v1.3 User's Guide - Manual (Page 25)

SMH5-FM
26
11.8.4 Scan and Save
“Scan” is the function that searches from the current station frequency
upward for stations in a whole range of FM frequencies. To use the
scan function, please follow the procedures below:
1. Double tap the Phone Button. Then the current station frequency
moves upward to find other station frequencies.
2. If the tuner finds a station, it stays at the station frequency for 8
seconds, then scanning to the next station frequency.
3. Scan function stops when you double tap the Phone Button again.
4. To save a station while scanning frequencies, tap the Phone Button
when at that station. You will hear a voice prompt from the SMH5-
FM saying “Save preset (#)”. The station will be saved as the next
preset number.
5. All stations preset during “Scan”, will overwrite previously set
stations.
6. To stop scan function, double tap the Phone Button.
11.8.5 Temporary Preset
With the temporary preset function, you may temporarily preset
stations automatically without changing the existing preset stations.
Tap the Phone Button three times which will automatically scan for
10 temporary preset stations. The temporary preset stations will be
cleared when the system is powered off.
11.9 Stereo Music
You can listen to stereo music by Bluetooth wireless stereo. The
Bluetooth audio device must be paired with the SMH5-FM by following
the Bluetooth Stereo Device Pairing instructions described in the 6.2
chapter. The SMH5-FM supports the Audio/Video Remote Control
Profile (AVRCP), so if your Bluetooth audio device also supports
the AVRCP, you can use the SMH5-FM to remotely control music
playback. So, you not only can adjust the volume but also use the
functions such as play, pause, next track and previous track.
- To adjust the volume, rotate the Jog Dial.