Sena Bluetooth SMH5-FM v1.3 User's Guide - Manual (Page 18)

English
SMH5-FM
19
10.2 Enabling/Disabling RDS AF
RDS AF allows a receiver to re-tune to a different frequency providing
the same station has an additional frequency. In RDS AF, the receiver
will “re-tune” to the second frequency location when the first signal
becomes too weak. With RDS AF enabled on the receiver, a radio
station with more than one frequency can be used. Tap the Phone
Button to enable the RDS AF.
Voice Prompt “RDS AF”
Factory Default Disable
Enable Tap the Phone Button
Disable Tap the Jog Dial
Note:
RDS feature may be available when radio channel station provides
equivalent service.
2. Tap the Phone Button, and you will hear a voice prompt saying
“Speed dial one” and “Phone connected”.
3. Rotate the Jog Dial to select one of three speed dial numbers and
you hear a voice prompt saying “Speed dial (#)”.
4. Call a phone number you want to assign and you will hear a
voice prompt saying “Save speed dial (#)”. The phone number is
automatically assigned to the selected speed dial number. Then
the phone call will hang up before being connected.
5. To exit the menu, rotate the Jog Dial clockwise or counter
clockwise until you hear a voice prompt saying “Cancel”, and tap
the Phone Button to confirm. You will then hear a voice prompt
saying “Cancel”. If any button is not pressed within 1 minute, the
SMH5-FM will exit the configuration menu and go back to stand-
by mode.
Note:
1. After assigning a phone number to one of three speed dials, you can
continually assign another phone number to the rest of two speed
dials.
2. You can assign phone numbers to speed dials in your PC. Please
visit the Sena Bluetooth web site at www.SenaBluetooth.com for more
information.