Disposal, Certification and safety approvals, Fcc compliance statement – Sena Bluetooth SMH5 v1.3 User's Guide User Manual
Page 28

English
SMH5
29
DISPOSAL
The crossed-out wheel bin symbol on the product, 
literature, or packaging reminds you that all electrical 
and electronic products, batteries, and accumulators 
must be taken to separate collection at the end of their 
working life. This requirement applies to the European 
Union and other locations where separate collection 
systems are available. To prevent possible harm to the environment 
or human health from uncontrolled waste disposal, please do not 
dispose of these products as unsorted municipal waste, but hand it 
in at an official collection point for recycling. 
CERTIFICATION AND SAFETY APPROVALS
FCC Compliance Statement
This device complies with part 15 of the FCC Rules. Operation is 
subject to the following two conditions:
•	 This device may not cause harmful interference.
•	 This device must accept any interference received, including 
interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency 
energy and, if not installed and used in accordance with the instructions, 
may cause harmful interference to radio communications. However, 
there is no guarantee that interference will not occur in a particular 
installation. If this equipment does cause harmful interference to 
radio or television reception, which can be determined by turning 
the equipment off and on, the user is encouraged to try to correct the 
interference by one or more of the following measures:
•	 Reorient or relocate the receiving antenna.
•	 Increase the separation between the equipment and receiver.
