Sena Bluetooth SMH5 v1.3 User's Guide - Manual (Page 18)

English
SMH5
19
10.2 Enabling/Disabling Voice Activated Phone Answering
Voice Prompt “VOX phone”
Factory Default Enable
Enable Tap the Phone Button
Disable Tap the Jog Dial
If this feature is enabled, you can answer incoming calls by simply
saying a word loudly enough. For example, when you hear a series
of beeps for an incoming call, you can answer the phone by saying
“Hello” or any other word loudly. This is enabled from the factory but
you can disable this. If this mode is disabled, you have to tap the Jog
Dial or the Phone Button to answer an incoming call.
10.3 Enabling/Disabling Voice Prompts
Voice Prompt “Voice prompt”
Factory Default Enable
Enable Tap the Phone Button
Disable Tap the Jog Dial
You can disable voice prompts by configuration setting, but the
following voice prompts are always on.
- Voice prompts for configuration setting menu
- Voice prompts for battery level Indicator
- Voice prompts for factory reset
10.4 Delete all Bluetooth Pairing Information
Voice Prompt “Delete all pairings”
Factory Default N/A
Execute Tap the Phone Button
To delete all Bluetooth pairing information of the SMH5, rotate the Jog
Dial until you hear a voice prompt saying “Delete all pairings”, and
tap the Phone Button to confirm. Taping the Jog Dial is not available
for this setting.
10.5 Exit Voice Configuration Menu
Voice Prompt “Exit configuration”
Factory Default N/A
Enable Tap the Phone Button
To exit voice configuration menu and get back to stand-by mode,
rotate the Jog Dial until you hear a voice prompt saying “Exit
configuration”, and tap the Phone Button to confirm. Tapping the
Jog Dial is not available for this setting.