Peerless-AV DST660 - Installation - Manual (Page 9)

9 of 9 ISSUED: 12-16-11 SHEET #:125-9272-1
Thread two M5 x 15 mm socket pin screws ( Q) into bottom holes of wall plate (A) leaving 1/8" space between
head of screw and wall plate as shown in figure 6.1. Guide hook slots of adapter plate ( B) onto screws (Q), while
supporting weight of screen, align top holes of wall plate and adapter bracket to the desired tilt angle and secure
with two M5 x 15 mm socket pin screws ( Q) as shown in figure 6.2. Tighten all screws securely.
6
Attaching Adapter Plate to Wall Plate
NO TILT
5° TILT
10° TILT
1/8"
HOOK
SLOTS
BOTH SIDES
NOTE: When display is in portrat position make sure that top screw (Q) is foward as shown in fig. 7.1.
Loosen top two M5 x 15 mm socket pin screws (
Q) 1/4 turn and temporarily remove bottom two M5 x 15 mm socket
pin screws ( Q) on adapter plate (A) as shown in figure 7.2. Swing screen forward and swing support brackets
downward into adapter plate ( B) to brace screen in open position as shown in figure 7.3.
7
Accessing CPU
SUPPORT BRACKETS
(BOTH SIDES)
LOOSEN 1/4 TURN ON
BOTH SIDES
REMOVE
REMOVE
fig. 7.2 fig. 7.3
WALL NOT SHOWN FOR CLARITY
A
B
Q
B
A
Q
fig. 6.1 fig. 6.2
Q
BOTH SIDES BOTH SIDES
Q
Q
fig. 7.1
BOTH SIDES
Q
USE TOP HOLE
WHEN NOT USING
DEDICATED TILT
TOP HOLE