Peerless-AV HLG442-SH - Installation - Manual (Page 6)

ISSUED: 12-05-08 SHEET #: 090-9160-4 10-05-09
Visit the Peerless Web Site at www.peerlessmounts.com For customer care call 1-800-729-0307 or 708-865-8870.
6 of 7
Choose the correct mounting hole pattern shown on
page 5 for mounting adapter plate (B) to LCD stand.
Position adapter plate (B) with hook flanges facing
bottom and locking tab facing back. Attach adapter
plate (B) to LCD stand using four, five or six M5 x 30
mm Phillips screws (I) and optional spacers (H or N).
Note: Remove rubber pads on LCD stand that prevent a
flush fit of adapter plate to LCD stand.
2
HOOK FLANGES FACE
BOTTOM
BACK OF LCD STAND
LOCKING TAB FACES
BACK
I
B
LCD STAND MAY APPEAR DIFFERENT
THAN ILLUSTRATED
H or N
P
LOCKING TAB
FACES BACK
HOOK FLANGES
FACE BOTTOM
BACK OF
LCD STAND
B
LC-32SB27U and LC-32D47U Stands Only
Attach adapter plate (B) to LCD stand using four
M5 x 20 mm Phillips screws (P) and optional spacers
(D and H). Note: Remove rubber pads on LCD stand
that prevent a flush fit of adapter plate to LCD stand.
H
D
NOTE: IF NOT USING SPACERS THEN BE SURE NOT TO
OVERTIGHTEN THE SCREWS AS THIS MAY CAUSE THE
ADAPTER PLATE TO BOW
Choose the correct mounting hole pattern shown on page 5 for mounting adapter plate (B) to LCD stand. Remove pre-
existing fasteners and cover from stand. Position adapter plate (B) with hook flanges facing bottom and locking tab
facing back. Attach adapter plate (B) to LCD stand using four M5 x 30 mm Phillips screws (I) and optional
spacer (H). Note: Remove rubber pads on LCD stand that prevent a flush fit of adapter plate to LCD stand.
LC-32E67U Stands Only
REMOVE PRE-EXISTING
FASTENERS FROM BASE
REMOVE COVER
BACK OF
LCD STAND
HOOK FLANGES
FACE BOTTOM
B
I
LOCKING TAB
FACES BACK
H
LCD STAND MAY APPEAR DIFFERENT
THAN ILLUSTRATED
NOTE: IF NOT USING SPACERS THEN BE SURE NOT TO
OVERTIGHTEN THE SCREWS AS THIS MAY CAUSE THE
ADAPTER PLATE TO BOW
2