Peerless-AV DS-VW665 - Installation - Manual (Page 5)

5 of 11 ISSUED: 03-22-12 SHEET #: 125-9288-4 06-25-13
Visit the Peerless Web Site at www.peerless-av.com For customer care call 1-800-865-2112 or 708-865-8870.
E
Installation to Wall Stud
Use a stud finder to locate the edges of the stud. Use of an edge-to-edge stud finder is highly recommended.
Based on their edges, draw a vertical line down the stud center. Place mount assembly ( A) on wall as a
template. Level plate, and mark the center of the four mounting holes. Make sure that the mounting holes are on
the stud center line. Drill four 5/32" (4 mm) dia. holes 2-1/2" (65 mm) deep. Make sure that the mount assembly
( A) is level, secure it using four #14 x 2.5” wood screws (E) and fender washers (G) as shown below.
• Installer must verify that the supporting surface will safely support the combined load of the equipment and all
attached hardware and components.
• Tighten wood screws so that wall plate is firmly attac hed, but do not overtighten. Overtightening can damage the
screws, greatly reducing their holding power.
• Never tighten in excess of 80 in. • lb (9 N.M.).
• Make sure that mounting screws are anchored into the center of the stud. The use of an "edge to edge" stud finder
is highly recommended.
• Hardware provided is for attachment of mount through standard thickness drywall or plaster into wood studs.
Installers are responsible to provide hardware for other types of mounting situations.
WARNING
1
A
STUD
G
SIDE VIEW
MOUNTING
SURFACE
SCREEN
DIRECTION
Note: Mount assembly (A) can
be installed to surfaces with a
maximum angle of 45°.
45°