Peerless-AV PRS-1S - Installation User Manual
Page 2
ISSUED: 08-15-07 SHEET #: 055-9188-7 01-18-11
Visit the Peerless Web Site at www.peerlessmounts.com
2 of 13
For customer care call 1-800-865-2112 or 708-865-8870.
Table of Contents
Parts List............................................................................................................................................................................ 3
Installation to Extension Columns / Ceiling Plate .............................................................................................................. 4
Installation to Wood Joist Ceilings ..................................................................................................................................... 5
Installation to Concrete Ceilings ........................................................................................................................................ 6
Installation to Threaded Rods ............................................................................................................................................ 7
Attaching Adapter Plate to Projector.................................................................................................................................. 8
Attaching Adapter Plate to Projector Mount....................................................................................................................... 9
Cable Management ......................................................................................................................................................... 10
Projector Alignment ......................................................................................................................................................... 11
Accessories ............................................................................................................................................................... 12, 13
NOTE: Read entire instruction sheet before you start installation and assembly.
• Do not begin to install your Peerless product until you have read and understood the instructions and warnings con-
tained in this Installation Sheet. If you have any questions regarding any of the instructions or warnings, please call
Peerless customer care at 1-800-865-2112.
• This product should only be installed by someone of good mechanical aptitude, has experience with basic building
construction, and fully understands these instructions.
• Make sure that the supporting surface will safely support the combined load of the equipment and all attached hard-
ware and components.
• Never exceed the Maximum UL Load Capacity. See page 1.
• If mounting to wood joist ceilings, make sure that mounting screws are anchored into the center of the joist. Use of an
"edge to edge" stud fi nder is highly recommended.
• Always use an assistant or mechanical lifting equipment to safely lift and position equipment.
• Tighten screws fi rmly, but do not overtighten. Overtightening can damage the items, greatly reducing their holding
power.
• This product is intended for indoor use only. Use of this product outdoors could lead to product failure and personal
injury.
• This product was designed and intended to be mounted to the following supporting surfaces checked below with the
hardware included in this product as specifi ed in the installation sheet. To mount this product to an alternative sup-
porting surface, contact Peerless customer care at 1 800 865-2112.
• This product was designed to be installed on the following ceiling construction only;
CEILING CONSTRUCTION
ADDITIONAL HARDWARE REQUIRED
x Wood
Stud
None
x
Wood
Joist
None
x
Solid
Concrete
None
Cinder Block
Contact Customer Service (Not Evaluated by UL)
Metal Stud
Do not attach except with Peerless accessory kit for metal studs;
Contact Customer Service for Peerless accessory kit for metal studs.
(Not
Evaluated
by
UL)
Brick
Contact Customer Service (Not Evaluated by UL)
Other or unsure?
Contact Customer Service (Not Evaluated by UL)
WARNING
Tools Needed for Assembly
• stud fi nder ("edge to edge" stud fi nder is recommended)
• phillips screwdriver
• drill
• 5/16" bit for concrete surface
• 5/32" bit for wood studs
• level