Peerless-AV PRS-1S - Installation - Manual (Page 11)

ISSUED: 08-15-07 SHEET #: 055-9188-7 01-18-11
Visit the Peerless Web Site at www.peerlessmounts.com
11 of 13
For customer care call 1-800-865-2112 or 708-865-8870.
To adjust yaw (swivel) for wood stud, concrete ceiling, and threaded rod mounting applications: Loosen
wood screws (F), or locknuts for threaded rods, until projector mount can be rotated. Rotate mount to desired posi-
tion and retighten screws or locknuts.
To adjust yaw (swivel) for extension column applications: Loosen screw on projector mount assembly (A) indi-
cated below until projector mount can be rotated. Rotate mount to desired position and retighten screw.
To adjust pitch (forward and backward tilt): Loosen two screws on projector mount assembly (A) indicated be-
low. Tilt mount to desired position and retighten screws.
To adjust roll (side to side tilt): Loosen two screws on projector mount assembly (A) indicated below. Tilt mount
to desired position and retighten screws.
Projector Alignment
A
9
SCREWS FOR PITCH
ADJUSTMENT
SCREW FOR SWIVEL STOP
SCREWS FOR ROLL
ADJUSTMENT