Peerless-AV PRS-1S - Installation - Manual (Page 10)

ISSUED: 08-15-07 SHEET #: 055-9188-7 01-18-11
Visit the Peerless Web Site at www.peerlessmounts.com
10 of 13
For customer care call 1-800-865-2112 or 708-865-8870.
Cable Management
To make an opening to route cables through projector
mount assembly, adjust projector mount assembly to full
upward tilt position by turning knob for tilt adjustment
as shown in fi gure 8.2. Left or right roll position can be
adjusted if more space is required.
NOTE: Be certain tamper resistant screws are not
engaged before making adjustments (see step 9).
Route cables through top of extension column as shown
in fi gure 8.1 and fi gure 8.2.
NOTE: A method for assisting cables through extension
column may be required (example: string tied to connec-
tor to help pull through extension column).
Route cables through projector mount assembly as
shown in fi gure 8.2 and connect to projector.
8
DO NOT
CRIMP
WIRES
BEND WIRES OF RCA
PLUGS IN OPPOSITE
DIRECTION
NOTE: INNER DIAMETER OF
EXTENSION COLUMN MAY NOT
ALLOW PASSAGE FOR ALL
CONNECTOR TYPES.
ROUTE
CONNECTOR
THROUGH
FIRST
CABLES WITH COMBINATION
OF VGA CONNECTOR
AND RCA PLUGS
INNER
DIAMETER OF
EXTENSION
COLUMN
CABLE
CONNECTOR
fi g. 8.1
fi g. 8.2
EXTENSION
COLUMN
OPENING FOR
ROUTING CABLES
SCREWS FOR ROLL
ADJUSTMENT
SCREWS FOR PITCH
ADJUSTMENT