Peerless-AV SC551GL - Installation User Manual

Page 9

9 of 35

ISSUED: 02-25-11 SHEET #: 009-9050-3 09-09-13

Begin with the shortest length screw, hand thread screw through multi-washer and display brackets (

B) into

display as shown. Screw must make at least three full turns into the mounting hole and fit snug into place. Do not

over tighten. If screw cannot make three full turns into the display, select a longer length screw from the baffled

fastener pack. Repeat for remaining mounting holes, level display brackets and tighten screws.
NOTE: Spacers may not be used, depending upon the type of display.

Begin with the longest length screw, hand thread screw through multi-washer, display brackets (

B) and spacer

in that order into display as shown. Screw must make at least three full turns into the mounting hole and fit snug

into place. Do not over tighten. If screw cannot make three full turns into the display, select a shorter length screw

from the baffled fastener pack. Repeat for remaining mounting holes, level display brackets and tighten screws.

For Flat Back Display

For Bump-out or Recessed Back Display

6-1

6-2

DISPLAY

MULTI-WASHER (

GG)

MULTI-WASHER (

GG)

SCREW

(AA,CC,EE)

(BB,DD,FF)

SPACER (

HH)