Peerless-AV PLA50-UNLP-GB - Installation - Manual (Page 9)

9 of 41 ISSUED: 06-05-06 SHEET #: 202-9140-10 (2013-10-01)
Insert two M10 screws (F) into swivel box on arm assembly (C) as shown. Leave approx. 1/4" of exposed thread.
Hook tilt-roll assembly (B) onto M10 screws (F).
Insert carriage bolt (I) into slot of swivel box as
shown in fi gure 6.1. Install nylon washer (G) and
tilt adjustment knob (H).
Install remaining two M10 screws (F) as shown in
fi gure 6.2. HAND TIGHTEN all four M10 screws
to allow for tilt adjustment. Remove tape from
carriage bolt (I). For tilt adjustment, push back
on the top of plasma to relieve pressure on knob.
Adjust tilt to desired position and tighten tilt adjust-
ment knob (H), then securely tighten all four M10
screws (F) using 6mm allen wrench (U).
• Use an assistant or mechanical lifting equipment to safely lift and position the plasma TV.
WARNING
• After tilt is adjusted, all fasteners must be tightened.
Failure to do so will result in damage to the mount.
CAUTION
6
6-1
6-2
SWIVEL BOX
C
fi g. 6.1 fi g. 6.2
SWIVEL BOX
I
B
F
H
G
H
F
I
Adapter bracket not shown for clarity. Adapter bracket not shown for clarity.
.25"
F