Peerless-AV PLA50-UNLP-GB - Installation - Manual (Page 7)

7 of 41 ISSUED: 06-05-06 SHEET #: 202-9140-10 (2013-10-01)
Snap four cable management clips (R) into top or bottom of arm assembly (C) as shown. Cable ties (S) are used
with clips for cord management.
Slide one mesh sleeve (T) over each cable. Use cable ties (S) to tighten mesh sleeves to cables.
NOTE: There are fi ve mounting positions.
The center position is shown (right).
Slide
washer (J) over wall support arm axle (D).
Next, insert plastic cap (N) into axle. Then,
insert holding pin (M) into axle. See detail 1.
R
S
C
2
3
T
3-1
Insert socket cap screw (K) into hole at bottom
of wall support arm axle (D) as shown in detail
3. Tighten screw using 9/64" allen wrench (Q).
NOTE: Fit of axle (D) into wall plate (A) and
arm assembly (C) will be tight. Gently tap into
place with a hammer if necessary.
N
J
D
M
J
C
DETAIL 1
Place arm assembly (C) with washer (J) into
wall plate (A). Insert axle assembly shown in
detail 1 through wall plate (A), arm assembly
(C), and washer (J). Lock axle in place by
aligning holding pin (M) with notches shown in
detail 2.
2-2
NOTCH
DETAIL 2
• If you are uncertain that product is properly installed, call customer care.
WARNING
K
D
DETAIL 3
2-1
A