Peerless-AV PLA50-UNLP-GB - Installation - Manual (Page 13)

13 of 41 ISSUED: 06-05-06 SHEET #: 202-9140-10 (2013-10-01)
If it is too diffi cult to adjust roll of plasma, loosen screws shown in fi gure 9.1 using a phillips screwdriver.
IMPORTANT! Do not loosen or tighten screws more than 1/8 turn.
Depending on the specifi c size & weight of the plasma, articulating swing arm may be angled at different posi-
tions, causing plasma to appear to lean sideways at different articulating positions. Tilt-roll assembly (B) allows
plasma to be manually adjusted, so plasma can be horizontal at all positions. To adjust, gently rotate plasma by
hand to desired position.
9
9-1
ARTICULATING
ARM
PLASMA
© 2013, Peerless Industries, Inc. All rights reserved.
All other brand and product names are trademarks or registered trademarks of their respective owners.
fi g. 9.1
ROLL
ADJUSTMENT
SCREWS