Peerless-AV LCC-36S - Installation - Manual (Page 7)

7 of 12 ISSUED: 09-27-04 SHEET #: 100-9004-8 10-08-12
Flush Mount Installation
B
D
Screw reducer (D) into ceiling plate (B) until notch
in reducer is aligned with one of the four holes in
ceiling plate and set screw (I) is at least partially
covered by ceiling plate as shown in fi gure 3.1.
Secure reducer with one M5 x 10 mm F-type
socket pin screw (P) using security allen wrench
(G) as shown in fi gure 3.2. Note: Slotted set
screw (N) is used to jam against the threads of
the reducer to prevent any excess movement of
the tube assembly (A). Do not overtighten screw;
overtightening screw will damage threads making
it diffi cult to separate the products.
Skip to step 4 on page 10.
I
P
SLOT
SLOT
D
ACC810 (SOLD
SEPARATELY)
1/2 -13 THREADED
ROD
Screw threaded rod adapter (ACC810) into extension
column connector (ACC109). Align slot in threaded
rod adapter with one of the top holes in extension
column connector. Insert and tighten one #10-32 x
3/8" socket pin screw provided with extension column
connector through extension column connector into
slot on threaded rod adapter using 4 mm security
allen wrench (G). See fi gure 3.3.
Align slot in reducer (D) to one of the bottom holes
in extension column connector. Insert and tighten
one #10-32 x 3/8" socket pin screw provided with
extension column connector through extension
column connector into slot in reducer. See fi gure 3.4.
Note: Slotted set screws provided with extension
column connector are used to jam against the
threads of each connecting joint to prevent any
excess movement. Do not overtighten screws;
overtightening screws will damage threads making
it diffi cult to separate the products.
Skip to step 4 on page 10.
ACC109
ACC810
THREADED
ROD
ACC810
THREADED
ROD
SLOT
D
Installation to
Threaded Rod
Accessory ACC810 (not evaluated by UL),
threaded rod adapter, is required.
SOCKET
PIN
SCREW
ACC109
SOCKET
PIN
SCREW
ACC109
(SOLD SEPARATELY)
fi g. 3.3
fi g. 3.4
A
N
SET
SCREW
SET
SCREW
SLOT
3
3
fi g. 3.1
fi g. 3.2