Warning, Ac d – Peerless-AV LCW620AD - Installation User Manual

Page 4

4 of 10

ISSUED: 07-25-11 SHEET #: 090-9206-5 11-29-12

Installation to Wood Stud Wall

Use a stud fi nder to locate the edges of the studs and draw a vertical line down the stud’s center. Place wall plate
(A) on wall as a template. Drill two 5/32" (4mm) dia. holes to a depth of 2" (50mm). Attach wall plate (A) to wall
with two wood screws (C) and two washers (D).

• Installer must verify that the supporting surface will safely support the combined load of the equipment and all

attached hardware and components.

• Tighten wood screws so that wall plate is fi rmly attached, but do not overtighten. Overtightening can damage the

screws, greatly reducing their holding power.

• Never tighten in excess of 80 in. • lb (9 N.M.).

• Make sure that mounting screws are anchored into the center of the stud. The use of an "edge to edge" stud fi nder

is highly recommended.

• Hardware provided is for attachment of mount through standard thickness drywall or plaster into wood studs.

Installers are responsible to provide hardware for other types of mounting situations.

WARNING