Peerless-AV HP437-C# (52-63) - Installation - Manual (Page 6)

6 of 9
ISSUED: 12-13-2013 SHEET #: 125-9086-9
Visit the Peerless Web Site at www.peerless-av.com For customer care call 1-800 865-2112
5 6
Line up backer plate ( B) with threaded rods
( N or O).
NOTE: Washer (H) must be centered.
FRONT OF
SCREEN
Detail 1
B
N or O
fig. 5.1
C
C
Using four fender washers ( T) and four lock nuts (P)
tighten in numbered pattern as shown in Figure 6.1.
At minimum 1/4 - 20 locknuts ( P) should be flush with
bottom of threaded rods ( N or ).
Line up base assembly (step 5), through supporting
surface with pattern of base ( C) facing the front as
shown in Detail 1.
2
3
1
4
FRONT OF
SCREEN
fig. 6.1
T
N or O
Mounting using Non-Security
Mounting using Security Slope Nuts (Optional)
Detail 4
TIGHTENING
SLOPE NUT (I)
I
5/8" OPEN BOX WRENCH
TIGHTENING
SLOPE NUT (I)
N or O
N or O
I
Detail 2 Detail 3
I
For added security replace two of
the washers and locknuts with slope
nuts.
Hand tighten slope nuts ( I) onto
two of the thread rods ( M) till snug
against bottom of table as shown in
Detail 2.
Thread another slope nut ( I) upside-
down, about two turns from first
slope nut ( I) as shown in Detail 3.
Insert a 5/8
" open box wrench
between both slope nuts ( I) and
tighten
as shown in detail 4.
7
BOTTOM OF DESK
BOTTOM OF DESK
NOTE: Avoid jamming both slope nuts (I) together,
doing so may make it difficult to remove slope nut
used for tightening.
After slope nut is secure remove bottom slope nut.
LEAVE SPACE
IN BETWEEN
SLOPE NUTS