Peerless-AV HP437-C# (52-63) - Installation - Manual (Page 4)

4 of 9
ISSUED: 12-13-2013 SHEET #: 125-9086-9
Visit the Peerless Web Site at www.peerless-av.com For customer care call 1-800 865-2112
1
BOTTOM VIEW
FRONT OF DISPLAY
SQUARE FORMATION
B
CABLE MANAGEMENT
CUT-OUT
fig. 1.1
Turn base ( C) upside down insert support tube (A),
and thrust washer ( H) as shown below.
A
C
H
fig. 3.1
2 3
N or O
C
fig. 2.1
• Wooden mounting surface requires a minimum of 3/4" thickness to hold display securely
WARNING
If the desk thickness is 3/4" use 1/4-20 x 1.5"
threaded rods ( N). If the desk thickness is between
3/4" to 2-1/4" use 1/4-20 x 3" threaded rods ( O). Turn
base ( C) upside down and insert four threaded rods
( N or O) into base (C), as shown below.
NOTE: Threaded rods must fasten a minimum of
three turns.
NOTE: If enhanced security is desired, use three
drops of loc-tite 271 thread lock adhesive ( R) along
1/4" at the end of each threaded rod. Insert adhesive
end of threaded rods ( N or O) into bottom of base
( C).
Use base backer plate ( B) as a template to mark location of holes. Drill four holes using a 17/64'' drill bit in a
square formation. In the center of the square formation drill a 2" to 3" cable management hole.