Peerless-AV PLAV60-UNLP-GB - Installation - Manual (Page 13)

13 of 41 ISSUED: 06-05-06 SHEET #: 202-9141-11 (2013-10-01)
FOR PLAV60 ONLY:
Position of display may be adjusted vertically up to .79" in
each direction by doing the following:
• To lower display, turn socket screw shown in fi gure 10.1
clockwise with 10mm allen wrench (V).
• To raise display, turn socket screw shown in fi gure 10.1
counterclockwise with 10mm allen wrench (V).
If it is too diffi cult to adjust roll of plasma, loosen
screws shown in fi gure 9.1 using a phillips screw-
driver.
IMPORTANT! Do not loosen or tighten screws
more than 1/8 turn.
Depending on the specifi c size & weight of the plas-
ma, articulating swing arm may be angled at different
positions, causing plasma to appear to lean sideways
at different articulating positions. Tilt-roll assembly (B)
allows plasma to be manually adjusted, so plasma
can be horizontal at all positions. To adjust, gently
rotate plasma by hand to desired position.
9
9-1
10
SOCKET
SCREW
fi g. 10.1
fi g. 9.1
ROLL
ADJUSTMENT
SCREWS
ARTICULATING
ARM
PLASMA
© 2013, Peerless Industries, Inc. All rights reserved.
All other brand and product names are trademarks or registered trademarks of their respective owners.