Peerless-AV PANA-85WM - Installation - Manual (Page 7)

7 of 8 ISSUED: 12-18-09 SHEET #: 125-9090-4 03-24-11
To make sure bracket assembly keyhole are properly aligned with standoffs, position bracket assembly
onto display standoffs.
Remove bracket assembly from back of display.
Secure tilt plate ( B) of bracket assembly to wall plate (A) at desired tilt angle using six M8 x 15 mm phillips screws
( F), six 5/16 split washers (J), and six 5/16 washers (K).Secure one M8 x 15 mm phillips screws (F), 5/16 split
washer ( J), and 5/16 washer (K) into slot of tilt plate (B) as shown in Detail 1.
4
5
Landscape Portrait
F
J
K
F,J, and K
F
J
K
A
B
A
B 0°
5°
10°
Slot
Display
Mounting Surface
Not Shown for Clarity
B
Detail 1