Peerless-AV DS-VWC560 - Installation - Manual (Page 7)

7 of 12 ISSUED: 03-08-11 SHEET #: 125-9195-5 09-20-12
Visit the Peerless Web Site at www.peerlessmounts.com For customer care call 1-800-865-2112.
6
Attach horizontal rails ( D) onto vertical supports (A) using sixteen 1/4-20 x 3.5" hex head screws (J), 1/4" SAE
washers [ 6mm] (H) and 1/4-20 nylock nuts (K) as shown in detail 1. Make sure that horizontal rails (D) are level
then tighten all 1/4-20 x 3.5" hex head screws ( J). Place two tube caps (R) into tops of vertical supports (A)
as shown in detail 2. NOTE: horizontal rails (D) must be secured using sixteen 1/4-20 x 3.5” hex head screws (J).
A
F
K
J
D
D
A
J
J
DETAIL 2
R
CABLE MANAGEMENT
7
Run display cables though top and bottom openings
in vertical supports ( A) as shown.
NOTE: Display cables can be covered using
18" mesh sleeve ( M) before securing.
Display cables can be secured to horizontal rails ( D)
using eight cable ties ( Q) as needed through slots in
horizontal rails ( D).
Q
DISPLAy CAbLES
M
D
bOTTOM
OPENING
TOP
OPENING
A
D
SLOT