Peerless-AV PRG-EXC-W - Installation - Manual (Page 11)

11 of 14 ISSUED: 04-24-08 SHEET #: 055-9257-7 07-15-11
Visit the Peerless Web Site at www.peerlessmounts.com For customer care call 1-800-865-2112
Attach adapter plate (B) to projector using one screw (J, K, L or M) for each channel as shown below. Tighten
all screws, while keeping the center of gravity. Be sure that adapter plate (B) is straight. Adjust the feet of the
channels to keep the adapter plate level. Tighten all screws with 4 mm security allen wrench (I) while keeping the
center of gravity. If M3 x 8 mm screws (J) are used, tighten using 2 mm security allen wrench (H).
NOTE: Projectors will require different size screws for mounting. Use a combination of screws (J, K, L or M) and
foot adjustment that will result in channels of adapter plate (B) fi tting tightly against projector. Important: In order
to properly engage the threads in the mounting holes, the screw must be turned at least 3 full turns.
NOTE: If using screw (J), place washer (G) between screw (J) and foot of channel.
• It is the responsibility of the installer to ensure that
the projector is properly ventilated. Feet of channels
are used to raise the mount off the projector surface.
CAUTION
J, K, L
or M
7
B
Slide connection block with projector into projector mount assembly (A) as shown. Push in and tighten captive
screw to secure projector to projector mount assembly (A).
CONNECTION BLOCK
A
FOOT OF CHANNEL
FRONT OF MOUNT
• Always use an assistant or mechanical lifting equipment to safely lift and position the projector.
WARNING
8
ARROW
INDICATES
FRONT OF
MOUNT
CAPTIVE SCREW
EE or FF