Peerless-AV PRG-EXC-W - Installation - Manual (Page 10)

10 of 14 ISSUED: 04-24-08 SHEET #: 055-9257-7 07-15-11
Visit the Peerless Web Site at www.peerlessmounts.com For customer care call 1-800-865-2112
ARROW INDICATES
FRONT OF MOUNT
CC
FF
fi g. 5.3
fi g. 5.4
FF
JJ
CC
Wall installation: Insert horizontal mounting plate (FF) into inner channel (CC) as shown in fi gure 5.3. Secure
horizontal mounting plate to inner channel using four M5 x 10 mm socket pin screws (JJ) as shown in fi gure 5.4.
WALL INSTALLATION
(EXCEPT FOR PRG-EXC MODELS)
5
GENERIC PROJECTOR
NOTE: The projector you are installing may differ in appearance from the sample illustrated below.
Place projector upside down. Locate adapter plate (B) with notch facing forward as close to projector center of
gravity as possible without covering any mounting holes. Loosen channels with 4 mm security allen wrench (I),
and if there are only three mounting holes remove fourth channel. Using one channel for each mounting
hole, position feet of channels over mounting holes as shown below. Important: If projector does not have at least
three mounting holes, do not use this adapter plate.
NOTE: Some projectors have feet which can be removed and the corresponding threaded insert can be used for
a mounting hole.
NOTE: Once channels are in position retighten fasteners.
*Notch indicates front of projector.
*
MOUNTING HOLE
6
CHANNEL
FOOT OF CHANNEL
Attaching Adapter Plate to Projector
B
A