Peerless-AV HP450 - Installation - Manual (Page 3)

ISSUED: 08-17-07 SHEET #: 090-9126-9 08-01-12
Visit the Peerless Web Site at www.peerless-av.com For customer care call 1-800 865-2112
3 of 6
Turn base ( C) upside down insert support tube (A),
and thrust washer ( F) as shown below.
If the desk thickness is 3/4" use 1/4-20 x 1.5"
threaded rods ( L). If the desk thickness is
between 3/4" to 2-1/4" use 1/4-20 x 3" threaded
rods ( M). Turn base (C) upside down and insert
four threaded rods ( L or M) into base (C), as
shown in figure 2.1.
Note: Threaded rods must fasten a minimum of
three turns.
Note: If enhanced security is desired, use
three drops of loc-tite 271 thread lock adhesive
( P) along 1/4" at the end of each threaded rod.
Insert adhesive end of threaded rods ( L or M) into
bottom of base ( C).
1
Use base backer plate ( B) as a template to mark location of holes. Drill four holes using a 17/64'' drill bit in a
square formation. In the center of the square formation drill 2" to 3" cord management hole.
A
C
F
fig. 3.1
2 3
L or M
C
fig. 2.1
• Wooden mounting surface requires a minimum of 3/4" thickness to hold screen securely
WARNING
B
SQuARe FoRMAtIoN
CoRD MANAGeMeNt
Cut-out FRoNt oF SCReeN
BottoM VIeW