Caution, Bi f – Peerless-AV PLA50 - Installation User Manual

Page 7

Text mode
Original mode

7 of 10

ISSUED: 05-03-06 SHEET #: 202-9127-4 06-29-11

GENERIC ADAPTER BRACKET

Insert and tape carriage bolt (I) into top hole of tilt-roll assembly (B). Attach tilt-roll assembly to adapter
bracket with four M10 socket screws (F). Tighten screws using 6 mm allen wrench (U).

Note: Adapter bracket (sold separately) will vary in size and style.

Note: Refer to adapter bracket instruction sheet for attachment of adapter bracket to plasma before proceeding
with step 5. If your adapter bracket has an aluminum race attached to it, remove before proceeding and discard race. It
is not used with this product.

• Do not overtighten screws! Overtightening may hin-

der roll option.

CAUTION

Attach two pieces of vinyl trim (E) to wall plate (A). Next, attach one piece of vinyl trim to bottom of swivel box on
arm assembly (C).

4-1

Insert one fi nishing cap (L) into each unused hole of wall plate (A).

SWIVEL BOX