Peerless-AV HDS-OWRE-200 - Installation - Manual (Page 5)

5 of 22 ISSUED: 08-24-12 SHEET #: 180-9030-1
Enclosure Wall Installation
Use a stud fi nder to locate the edges of the stud. Use of an
edge-to-edge stud fi nder is highly recommended. Based
on its edges, draw a vertical line down the stud’s center.
Place enclosure on wall as a template, making sure that two
vertical mounting holes are over the stud centerline. Level the
enclosure, and mark the center of the two holes. Drill two 5/32"
(4mm) dia. holes 2-1/2" (64mm) deep. Make sure that the
enclosure is level, secure it using two #14 x 2-1/2" wood screws
(C) as shown.
Skip to step 7.
A
C
• Installer must verify that the supporting surface will safely support the combined load of the equipment and all
attached hardware and components.
• Tighten wood screws so that the enclosure is fi rmly attached, but do not overtighten. Overtightening can damage
the screws, greatly reducing their holding power.
• Never tighten in excess of 80 in. • lb (9 N.M.).
• Make sure that mounting screws are anchored into the center of the stud. The use of an "edge to edge" stud fi nder
is highly recommended.
• Hardware provided is for attachment of mount through standard thickness drywall or plaster into wood studs. Install-
ers are responsible to provide hardware for other types of mounting situations.
WARNING
5
Open the wireless receiver enclosure (A) and remove the sub panel assembly as shown in fi g. 1.1. Choose two
holes for securing the wireless receiver enclosure (A). Press in plastic plug (F) into the four remaining holes
shown in fi gure 1.2.
1
fi g. 1.1 fi g. 1.2
A
F
A
SUB PANEL
ASSEMBLY
MOUNTING
HOLES
Installation to Single Wood Stud Wall