Peerless-AV HP447 - Installation - Manual (Page 5)

ISSUED: 06-19-12 SHEET #: 125-9327-4 08-6-12 5 of 7
2
3
1
4
5
Line up backer plate ( B) with threaded rods (M).
NOTE: Washer (F) must be centered.
FRONT OF
SCREEN
Detail 1
B
M
fig. 5.1
6
C
FRONT OF
SCREEN
F
Tighten in sequenced pattern Using four fender
washers ( L) and four lock nuts (N) as shown in
Figure 6.1. The 1/4-20 locknuts ( N) should at least be
flush with the bottom of the threaded rods ( M).
Line up base assembly (step 5), through supporting
surface with pattern of base ( C) facing the front as
shown in Detail 1.
fig. 6.1
L
N
Mounting using Non-Security
Mounting using Security Slope Nuts (Optional)
Detail 4
TIGHTENING
SLOPE NUT (G)
G
5/8" OPEN BOX WRENCH
TIGHTENING
SLOPE NUT (G)
M
M
G
Detail 2
Detail 3
G
For added security replace two of
the washers and locknuts with slope
nuts.
Hand tighten slope nuts ( G) onto
two of the thread rods ( M) until
snug against bottom of table as
shown in Detail 2.
Thread another slope nut ( G)
upside-down, about two turns from
first slope nut ( G) as shown in
Detail 3.
Insert a 5/8
" open box wrench
between both slope nuts ( G) and
tighten
as shown in detail 4.
7
BOTTOM OF DESK
BOTTOM OF DESK
NOTE: Avoid jamming both slope nuts (G) together,
doing so may make it difficult to remove slope nut
used for tightening.
After slope nut is secure remove bottom slope nut.
LEAVE SPACE
IN BETWEEN
SLOPE NUTS