Peerless-AV HP447 - Installation - Manual (Page 3)

ISSUED: 06-19-12 SHEET #: 125-9327-4 08-6-12 3 of 7
Turn base ( C) upside down insert support tube (A),
and thrust washer ( F) as shown below.
A
C
F
fig. 3.1
2 3
Turn base ( C) upside down and insert four threaded
rods ( M) into base (C), as shown below.
NOTE: Threaded rods must fasten a minimum
of three turns.
M
C
fig. 2.1
• Wooden mounting surface requires a minimum of 3/4" thickness to hold screen securely.
WARNING
1
Use base backer plate ( B) as a template to mark location of holes. Drill four holes using a 17/64'' drill bit in a
square formation. In the center of the square formation drill 2" to 3" cord management hole.
B
SQUARE FORMATION
CORD MANAGEMENT
CUT-OUT
FRONT OF SCREEN
BOTTOM VIEW